When you purchased your SafetyPro, the dealer could only offer a limited range of supplies. A label printer is only as good as the supplies that are available for that printer. If there are no supplies for making wire and cable labels, then you can not use the printer to make wire and cable labels... unless you give us a call.
We have a wide range of specialty supplies for the SafetyPro printer, including both shrink tubes and wire wraps. Both of these materials are used to label wires and cables.
Shrink tube slips over the end of a wire. A heat gun is used to shrink it to a tight fit on the wire. It provides a permanent marker that identifies the wire.
Self-laminating wire wraps have a opaque section on which the information is printed. It is applied to the wire or cable. Then a clear "tail" is wrapped around the wire or cable, covering and protecting the printed section. Since wire wraps are wrapped around the wire or cable, they may be applied at any time.
We have both types of materials in stock for the SafetyPro printer. Give us a call at 1-877-597-8833 for more information.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment